An ABS wheel speed sensor sits at each wheel and reads a toothed tone ring or magnetic encoder as the wheel turns. The anti-lock braking, traction control and stability control systems use those signals, and on many vehicles they also feed the speedometer and transmission. Sensors fail from damaged or chafed wiring, corrosion at the connector, metal debris on the magnetic tip or a cracked tone ring. The result is usually an ABS or traction control warning light. We stock ABS wheel speed sensors from several brands, led by Holstein. BMW and Mercedes-Benz have the most coverage, followed by Nissan, Audi and Toyota. Each sensor is specific to a wheel position, so confirm front or rear and left or right.
Right now we have 125 in stock from 8 brands.
Showing 1–24 of 138 resultsSorted by latest
Use a scan tool that reads ABS codes to find out which wheel is reporting the fault before ordering. Then match:
On some vehicles the sensor is built into the wheel hub assembly and cannot be bought on its own; in that case the whole hub is replaced.
The ABS module expects a specific signal type and strength, so the aftermarket sensor must match the original design, cable length and mounting depth. Quality replacements do this and are widely used by repair shops. If a sensor is listed for your vehicle and position, it is designed to fit the original mounting bore.
Wheel speed sensors have no service interval and are replaced only when they fail. Before replacing one, inspect the wiring and connector, since chafed cables and corroded pins are common causes of the same codes. Clean rust and debris from the mounting bore so the sensor seats fully, check the tone ring for cracks or missing teeth, and route the new cable through every original clip, away from suspension parts and the brake rotor. Clear the codes and test-drive; some vehicles turn the light off only after a short drive.
A scan tool that reads ABS codes will identify the wheel. Generic code readers often cannot see ABS faults.
Sometimes, but often the cable length or connector differs. Order the exact position listed for your vehicle.
No. Wheel speed sensors are usually replaced individually, only on the wheel with the fault.
On many vehicles the light goes out after the codes are cleared and the car is driven a short distance. If it stays on, check the wiring, connector and tone ring.
Yes. Email [email protected] or call (281) 271-4273 with your VIN and the wheel position, and we will confirm the right sensor.
Symptoms, causes and checks for these parts, from our repair guides.